- -
12
When the engine starts
IMPORTANT
For maximum vacuum performance and operating life, allow the
engine to warm before use.
1. Run the engine at idle speed until operating temperature is
reached(2 to 3 minutes)
2. As the engine warms, open the choke gradually by slowly
pushing the choke control in to the fully retracted position.
3. The machine should now be ready for use.
If the engine dose not start
Repeat the appropriate starting procedures for “hot” or “cold”
engine. If the engine still will not start, follow the “Starting a
Flooded Engine” procedure (below).
WAR NI NG!
Incorrect spark plug installation
Can result in serious engine
damage!
Starting a flooded engine
1. Disconnect the spark plug lead, and use the spark plug
wrench to remove the plug in a counterclockwise direction.
2. If the spark plug is fouled or is soaked with fuel, clean or
replace the plug as required.
3. Clean excess fuel form the combustion chamber by cranking
the engine several times while the spark is removed.
Choke
rod
To Next Page
Loading...