- -
8
WARNING!
Danger form rotating impeller! Stop the engine before
installing or removing the machine tubes! Never perform any
maintenance or assembly procedures on this machine while
the engine is running.
MIXING FUEL
Fuel requirements
□ Use only fresh, clean fuel
□ Use only fuel with an octane rating of 90 or high
□ Mix all fuel with premium 2-cycles engine oil at a
gasoline/oil ratio of 40:1
CAUTION!
Never attempt to mix fuel in the machine fuel tank! Always mix
all fuels in a clean. approved container!
Some gasoline contain alcohol as an oxy genated! Oxy genated
fuels may cause increased engine operating temperatures! Under
certain conditions, alcohol-based fuels may also reduce the
lubricating qualities of some mixing
oils! Never use any fuel containing more than 10% alcohol by
volume! When an oxygenated fuel must be used fuel containing
an ether-based oxygenates such as MTBE is to be
preferred over alcohol!
Whenever possible use 2-cycle oil or equivalent oil mixed at a
40:1 ratio. Be aware that generic oils and some outboard mixing
oils may note intended for use in high-performance air cooled
2-cycle engines, and should never be used in your engine
machine.
To Next Page
Loading...