OPERATING INSTRUCTIONS CHANGING THE ABRASIVE BELTDISC
13
WARNING!! KEEP TOOLS AND
EQUIPMENT OUT OF REACH OF
YOUNG CHILDREN
ALWAYS WEAR EAR DEFENDERS,
EYE PROTECTION AND DUST MASK.
CONNECT A DUST EXTRACTION
MACHINE TO THE SANDER.
MAKE SURE THE SANDER IS ON A
FLAT LEVEL SURFACE.
NOTE: GO ROUND AND MAKE SURE
EVERYTHING IS SECURE, FASTENED
DOWN, THAT ALL TOOLS ARE
CLEARED AWAY FROM THE WORK
AREA!
Connect your extraction hose to the sander’s outlet.
Give the machine a ‘quick’ burst check ( i.e. quick ON-OFF)
to ensure everything is O.K. If everything is satisfactory, the
Sander is ready for use.
63mm
CONNECT THE SANDER TO THE
MAINS SUPPLY!
DISCONNECT THE SANDER FROM
THE MAINS SUPPLY BEFORE
CONTINUING!
Sanding Disc
2
3
1
Remove the worktable (B) and place safely aside.
Remove the two screws holding the extraction plate and
place to one side.
Continues Over...
B
WEAR A DUST MASK &
EYE PROTECTION WHEN
CHANGING THE DISC!
To Next Page
Loading...