Note: To browse through the menu press channel up/down. The menu has two entries, one
for adjusting the power setting, displayed as ‘nP’ or ‘EP’, and one for adjusting the analogue
level displayed as ‘AL’.
Select option ‘’ AL’’ – the display will change to display the value of the set analogue level.
The analogue level can be adjusted by using the Vol up / down buttons to set as required.
When optimal level is found press the side PTT button to save and exit.
The standard factory setting is 78, but the optimal setting will depend on the type and output
of the microphone used and the noise levels in the operating environment. Typically a setting
between 60 and 80 will be used.
To Next Page
Loading...