Axon Fleet 2 Camera System User Manual
Axon Enterprise, Inc. Page 12 of 22
Recording with the Axon Fleet 2 System
The Axon Fleet 2 front and rear cameras can operate independently of each other.
Operating Modes
The Axon Fleet 2 camera system has 2 operating modes:
1. BUFFERING (turning on the camera and starting pre-event buffering)
2. EVENT (event recording)
BUFFERING Mode (Turning on the Camera)
• Move the power switch on the camera to the ON position.
With the camera turned on, the Axon system is in the BUFFERING mode. When BUFFERING
begins:
• The Operation LED on the back of the camera will blink green.
• The camera will be capturing video but does not record to permanent memory while
in BUFFERING mode.
• Buffered video duration is 30 seconds by default (00:00:30).
When EVENT mode is activated, the buffered video captured directly before the event is
saved and attached to the event in permanent memory. This feature is intended to
capture the video of an incident just before your activation of EVENT mode.
With default settings, the system does not capture audio in BUFFERING mode, so
anything recorded in that mode will be video-only. BUFFERING mode starts only after the
Axon Fleet system is turned on. The system does not record when the camera is turned
off.
Notes:
• An agency can extend the BUFFERING mode’s duration in 30 second increment up to
2 minutes total (00:02:00). There are some restrictions on video quality and buffering
settings.
• An agency can configure the BUFFERING mode so it records audio as well as video.
To Next Page
Loading...
Need help?
General
