Axon Fleet 2 Camera System User Manual
Axon Enterprise, Inc. Page 22 of 22
gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas celle
requise pour établir une communication satisfaisante.
THIS MODEL DEVICE MEETS THE GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO RADIO
WAVES
Section 6.8 of RSS-GEN
These radio transmitters IC: 8803A-S00947B and IC: 8803A-S00146B have been approved by
Innovation, Science and Economic Development Canada to operate with the antenna types
listed below, with the maximum permissible gain indicated. Antenna types not included in
this list that have a gain greater than the maximum gain indicated for any type listed are
strictly prohibited for use with this device.
Axon Fleet 2.0 Front camera uses a stamped metal dual band dipole. Antenna gain is <5.8dBi
at 2.4GHz, and <1.88dBi at 5.8GHz. The required impedance for this antenna is 50 ohms.
Axon Fleet 2.0 Rear camera uses a ceramic chip dual band antenna. Antenna gain is
<-4.15dBi at 2.4GHz, and <-0.3dBi at 5.8 GHz. The required impedance for this antenna is 50
ohms.
To Previous Page
Loading...
Need help?
General
