EasyManuals Logo

Axxess GMOS-05 User Manual

Axxess GMOS-05
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4
GMOS-05
From the 32-pin harness:
Connect the Yellow wire to the radio’s 12 volt battery or memory wire.
Connect the Black wire to the radio’s ground wire.
Connect the Blue wire to the antenna turn on wire of the aftermarket radio.
Connect the Green wire to the radio’s left rear positive speaker output.
Connect the Green/Black wire to the radio’s left rear negative speaker output.
Connect the Purple wire to the radio’s right rear positive speaker output.
Connect the Purple/Black wire to the radio’s right rear negative speaker output.
Plug the 14-pin harness into the GMOS-05
The Black/Yellow wire is for the OnStar volume adjustment. This will be discussed in
the OnStar Level Adjustment section of this instruction.
Installing the GMOS-05
With all connections completed to the aftermarket radio, plug the 32-pin harnesses into
the vehicles wiring harnesses.
Reconnect the negative battery terminal.
Cycle the key, by turning the ignition on for 30 seconds. Then off and on again
to test the radio.
Connections to be made

Other manuals for Axxess GMOS-05

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Axxess GMOS-05 and is the answer not in the manual?

Axxess GMOS-05 Specifications

General IconGeneral
BrandAxxess
ModelGMOS-05
CategoryRecording Equipment
LanguageEnglish

Related product manuals