EN-13
Under standby mode, if no any cooking zone heating operation, the
appliance w ill g o i nto s hutdown s tatus a utomatically a fter 1 0s a nd
beep once.
Heating control
Under standby mode, you can choose the cooking zone by pressing
the c ooking z one se lect b utton, t hen p ress plus o r minus b utton o r to
adjust the power level of the corresponding c ooking z one. Press and
hold plus “
” or minus “ ” buttons can continuously to increase or
decrease the power level.
When the h ob t op i s i n heating st atus, p ress a nd h old “
” power
button for 3s to switch off, and stop all the cooking zones to heat. The
corresponding cooking zone indicator of the hob top which has heated
before will display high temperature warning symbol “ ”.
Under st andby m ode, i f so me h ob t ops st ill e xist residual h eat, d isplay
will show “
”.
If needing to switch off one of the cooking zones, you can select that
zone f irst, then p ress t he m inus b utton “
” until “0” power l evel to
switch o ff that z one, a nd w ill n ot affect the h eating o f t he o ther
cooking z ones. When p ower l evel reaches “0”, t he corresponding
cooking z one i ndicator of t he h ob t op which h as h eated b efore w ill
display high temperature warning symbol “
”.
If m ore t han o ne z one is operating at the same time, total power will
equal to the sum of the powers of all the working cooking zones, each
cooking zone will work according to their power modulation ratio, and
will not affect each other.
Note: 1. During the same period,only one hob top button is valid,that is
only one decimal point “
” can be displayed.
2. Press minus button “
”to set the power level to “0”,then the
heating hob top will close automatically.
To Next Page
Loading...
