Ayre KX-R

The linked components may be joined in
any convenient order.
The linked components should be connected in daisy-chain
fashion, connecting each component to another until all of the
linked components have been connected.
When connecting the linked components to form
a chain, be careful not to connect the two ends of
the chain. Closing the chain to form a loop will
cause the AyreLink system not to function.
If there are no AyreLink-equipped source components in your
system, the power status of the KX-R preamplifier may also be
controlled by a trigger output from a source component. In this
case, AyreLink-equipped amplifiers may still be connected to
the KX-R. Connect the AyreLink ports of your amplifiers in
daisy-chain fashion as described above. The unused AyreLink
port on the KX-R preamplifier can then be used as a trigger
input. Additional details can be found in the chapter
“Optimization and Customization”.
AC Power
The KX-R may be plugged directly into an unswitched wall
outlet. Although proprietary RFI (radio-frequency interference)
filtering is built into the preamplifier, in some situations an AC
power-line filter (such as those offered by Ayre) may provide
additional sonic benefits.
6