Azbil NX-SVG - Specifications

E5
BATTERY
 Inserting the battery
The battery is not included with this device. Please purchase a
commercially available CR1632 that conforms to UL 1642 (CCN:
BBCV 2) as needed.
Be sure to insert or replace the battery when the power is OFF.
(1) Remove the main unit from the base. Place the battery on
the battery holder on the back of the main unit, tilting the
battery as shown below.
(2) Push the battery into the battery holder with your finger.
(3) Connect the main unit to the base.
(4) Set the date and time using the SLP-SVG Smart Loader
Package.
Handling Precautions
•
Be sure to insert the battery with the plus sign facing
upward.
 Removing the battery
(1) Remove the main unit from the base. Insert a non-metal
object with a flat tip between the battery and the battery
holder on the back of the main unit to make the battery
come out of the holder.
(2) Remove the battery with your fingers.
 Battery disposal
When discarding the battery, dispose of it appropri-
ately, following local regulations.
DISPOSAL
When disposing of this device, please remove the battery first and
dispose of the device appropriately as industrial waste in accordance
with local laws and regulations.
EU
SPECIFICATIONS
 Specifications
z Standard conditions
Ambient temperature: 23 ±2°C
Ambient humidity: 60 ±5%RH (without condensation)
Rated power voltage: 24VDC
Vibration resistance: 0m/s
2
Shock resistance: 0m/s
2
Mounting angle: Reference plane ±3°
z Operating conditions
Ambient temperature: 0 to 50°C (below the installed module)
Ambient humidity: 10 to 90%RH (without condensation)
Allowable power supply voltage for operation:
21.6 to 26.4VDC
Vibration resistance: 0 to 3.2 m/s
2
(10 to 150Hz for 2h each
in X, Y, and Z directions)
Shock resistance: 0 to 9.8 m/s
2
Mounting angle: Reference plane ±3°
Dust: 0.3 mg/m
3
max.
Corrosive gas: None
Altitude: 2000m max.
Pollution degree: 2 (equivalent to normal office
environments)
z Transportation conditions
Ambient temperature: −20 to +70°C
Ambient humidity: 5 to 95%RH (without condensation)
Vibration resistance: 0 to 9.8 m/s
2
(10 to 150Hz for 2h each
in X, Y, and Z directions)
Shock resistance: 0 to 300 m/s
2
(vertically shaken three
times while mounted on DIN rail)
Package drop test: Drop height 60cm (free fall on 1 cor-
ner, 3 sides, 6 planes)
z Other specifications
Insulation resistance: 500V DC, 20MΩ min. (between power
supply terminal and I/O terminals in-
sulated from the power supply terminal
1, 2)
Dielectric strength:
500V AC, 1min (between power supply
terminal and I/O terminals insulated
from the power supply terminal 1, 2)
Power consumption: 6W max.
Power ON inrush current:
10A max. (under operating conditions)
Power ON behavior: Requires approx. 30s before normal
operation begins (under standard
conditions)
Case material/color: Modified PPO resin, black
Mounting procedure: DIN rail
Terminal screw tightening torque:
0.6 ±0.1N·m
Mass: 300g max.
Standards compliance: CE (EN61326-1, For use in industrial
locations)
cUL (UL61010-1)