Press Simple Connect for two seconds on your HIPC700 HPCam. After you release the button,
the Power LED will blink. If the Power LED did not blink, press Simple Connect again for
two seconds.
Note: Do not press Simple Connect for more than two seconds.
Press Simple Connect for two seconds on HomePlug X. After you release the button, the
Power LED will blink. If the Power LED did not blink, press Simple Connect again for two
seconds.
Pairing between two devices are only given two minutes upon pressing the simple connect
button for two seconds. After pressing Simple Connect on HomePlug Y, make sure to press
Simple Connect on HomePlug X within two minutes to assure a successful connection,
otherwise repeat steps 2 and 3 until the LEDs of both devices switch off and on twice,
indicating that they are paired with one another.
Note: Do not press Simple Connect for more than two seconds
To Next Page
Loading...