User Manual
Page 7 of 43
Pairing the Device
Your HomePlug AV devices by default are preconfigured to have a common Private
Network Name. Setting up your HomePlugAV network is as easy as 1,2 and 3.
1. It is advisable that you plug in your HomePlugAV devices side by side to easily
observe the LED behaviors of each Homeplug AV. Wait until the Power and PL-ACT
LED turns ON to confirm that the connection has been established.
2. In ROOM A plug in your HomePlugAV into the wall outlet then connect it to your
Modem Router’s Ethernet LAN port using an Ethernet cable.
3. In ROOM B plug in your HIPC700 HPCam into the wall outlet then connect it to your
computer’s Ethernet Port using an Ethernet cable. Your HIPC700 HPCam is now ready
to use.
To Next Page
Loading...
Need help?
General