User Manual
Page 3
of 35
About the Device
Aztech WL556E Portable Wireless-N Repeater supports wireless
802.11b/g/n standards with one 10/100Base-T Ethernet port.
WL556E is designed with MIMO technology to extend the reach of any
existing wireless router/AP to maximize the coverage in your home or
office. It basically receives the signal from your wireless router/AP and
repeats it to extend the range to farther locations that are previously
unreachable.
Equipped with 64/128-bit WEP, WIFI Protected Access (WPA), and the
latest WPA2 encryption with TKIP and AES algorithm to protect your wireless
network from unauthorized access. MAC Address Filtering for wireless links
provides an additional layer of security for your wireless network.
The device comes with 1 x 10/100M Auto MDI/MDIx Ethernet port
that can be used to connect to an existing wired network to serve as a
wireless AP or wireless bridge. It can also be used to configure the device
via its web-based GUI, or upgrade the firmware when connected to the
Network Interface Card of your PC.
To Next Page
Loading...
Need help?
General
