AZTECH
Frequently Ask Questions
1. Why can’t I access the Web UI of my WL559E?
Ans:
Ensure that the Ethernet cable is connected to WL559E’s Ethernet port
through the computer’s Ethernet port via the Ethernet cable and that the
device is switch on.
Ans:
You may turn-off / disable your wireless network on your computer and
launch a Web browser it should redirect you to User Interface of the
WL559E (If in any case it does not type http://10.0.10.254 on your Web
browser Ex: Internet Explorer, Firefox, or Chrome etc.)
2. What if I want to change some configuration on my WL559E after it has been
previously configured and connected to my wireless AP/Router?
Ans:
If you are connected to the WL559E’s wireless network, you may just open
your Web browser and type http://10.0.10.254 to get to the Web user
interface; since there is no way that we can find out if we are connected to
the WL559E’s wireless network as they advertise the same wireless
network(SSID).
Ans:
Another way is to connect an Ethernet cable between WL559Eyou’re your
computer then access the Web user Interface by typing http://10.0.10.254
via the Web Browser.
3. Will the WL559E increase the range and throughput of my wireless AP/Router?
Ans:
The WL559E will extend the range of your wireless AP/router but it will
NOT increase the throughput due to the fact that all repeaters will sacrifice
half of the bandwidth available from the primary router for clients
wirelessly connected to the repeater. This is a result of the repeater taking
turns talking to not just one partner, but to two, and having to relay the
traffic between them.
To Next Page
Need help?
General
