Aztech WL559E

User Manual
Page 2 of 2
4. Can I connect a second WL559E to the current WL559E that I have already
connected to my wireless AP/router?
Ans:
It is possible to extend the wireless signal of your first WL559E by
connecting another WL559E to it. But you must understand that each time
the wireless signal is repeated, the repeated signal will be half of the
original. So in theory, if your wireless AP/router gives a total throughput of
about 50Mbps, after the 1st WL559E it will be around 25Mbps and
12.5Mbps after the 2nd WL559E. Actual throughput might be lower than
this after taking in consideration walls and other interference in the
wireless medium.
5. Can I use the WL559E with my old wireless-G AP/router?
Ans:
Yes. Even if the WL559E is a wireless-N repeater, it is backward compatible
with wireless b and g devices including AP and clients.
6. Why can't I connect to the Internet when I pressed the WPS on the WL559E?
Ans:
The WPS button on the WL559E is meant for connecting the device to
AP/Router and wireless client devices to the WL559E. When WPS is
activated, Light in Amber color will blink within 2 mins. If WL559E was
already connected to any AP/Router, Internet on the WL559E will stop to
scan for connecting AP/Router or wireless client. If in any case the
association is not successful you will need to reboot the WL559E to restore
its connection to the Internet.