AZURO P350 - User Manual

Questions and Answers

D
David LongAug 4, 2025
What to do if AZURO P350 Water Filtration Systems are not cleaning the swimming pool water properly?
- L
  Leslie CarpenterAug 5, 2025
  If you're experiencing issues with your AZURO Water Filtration System not adequately cleaning your swimming pool water, or if you notice overpressure and the filter needs frequent cleaning, consider these steps: * Ensure chlorine and pH levels are within the recommended range. * Verify sufficient flow rate through the filtration system. * Increase the duration of filtration unit operation. * Confirm the valve control lever is correctly set to the FILTER position. * Check the filtration unit's installation and connections for accuracy.
D
Danielle BestAug 14, 2025
How to increase water flow rate in AZURO P350?
- D
  dennismarioAug 14, 2025
  If you're experiencing a low water flow rate with your AZURO Water Filtration System, here are a few things to check: 1. Ensure the water level in your swimming pool is at the prescribed level. 2. Make sure the skimmer and pump pre-filter are clean. 3. Check for any restrictions in the inlet or outlet pipeline that might be affecting water flow. 4. Look for any air intake, indicated by bubbles coming from the return nozzle. 5. Consider washing the filter sand.
M
Matthew LopezAug 25, 2025
Why is the filtration cycle slow in my AZURO P350 Water Filtration Systems?
- C
  Christopher HughesAug 25, 2025
  If your AZURO Water Filtration System has a slow filtration cycle, consider the following: * Check for chalky sediment in the water and adjust water parameters if needed. * Ensure chlorine content and pH are within the recommended range; adjust if necessary. * Inspect the top sand layer for crusting or caking; remove the top two centimeters if present.