Instruction for use
10
En
PRO-33 / PRO-35
Only for model PRO-35:
If the LCD displays battery symbol the batteries are fi nishing. Please replace all batteries with new ones.
After the LCD displays battery symbol the monitor cannot open. Please replace all batteries with new ones.
Rechargeable batteries are not suitable for this monitor.
Remove the batteries if the monitor will not be used for a month or more to avoid relevant damage of battery leakage.
Avoid the battery fl uid to get in your eyes. If it should get in your eyes, immediately rinse with plenty of clean water and contact a
physician.
The monitor, the batteries and the cuff, must be disposed of according to local regulations at the end of their usage.
7.2. Using a mains adapter
1) Plug the mains adaptor into a 100-240 V, 50/60Hz power socket.
2) Plug the DIN plug into the socket at the
right side of the instrument.
No power is taken from the batteries while the mains adaptor is connected to the instrument.
Warning IIf you need mains adapter, You may purchase it separately. Use only the mains
adapter AD-155. The use of any other adapters can make your warranty void.
7.3. Connecting the cuff to the monitor
Insert the Air Tube Plug fi rmly into the Air Tube Socket on the side of the Monitor. Make
certain that the Plug is completely inserted in order to prevent air leakage during use.
Avoid compression or restriction of the connection tubing during measurement,
which may cause infl ation error, or harmful injury due to continuous cuff pressure.
7.4. Applying the cuff
a. Pulling the cuff end through the medal loop (the cuff is packaged like this already), turn it outward
(away from your body) and tighten it and close the Velcro fastener.
b. Place a cuff around a naked hand 1-2 cm higher than an elbow pole.
c. Being in a sitting position, put a hand palm up before yourself on a plain surface, for example, on a
table. Arrange a cuff on a hand so that its bottom edge was apart 1-2 cm above an elbow bend.
To Next Page
Loading...
