INSTRUCTIONS FOR USE
• Ensure the hair is dry and combed through to remove any tangles.
Divide the hair into sections ready for styling.
• Press the button marked ‘I/0’ to switch the appliance on.
• Slide the switch to select the suitable heat setting for your hair type.
The LED indicator light will ash until optimum temperature has been
reached. Once temperature has been reached the LED light will stop
ashing.
• Take a section of hair and place between the top barrels and bottom
plate of the appliance.
• Clamp the hair between the top barrels and bottom plate by pressing
the appliance together.
• Hold in place for 5-8 seconds. Take care to avoid the hot surfaces
of the appliance coming into contact with the skin, in particular the
eyes, ears, face and neck.
• Release the appliance from the hair and gently slide down to the next
section. Re-position the appliance to overlap the last wave created,
to ensure a continuous wave effect in the hair.
• Continue this action down the entire hair section, towards the ends
of the hair.
• Allow the section to cool before styling. Repeat on each hair section.
• After use, press the button marked ‘I/0’ to switch off and unplug the
appliance.
• Allow to cool before storing away.
Heat Settings
If you have delicate, ne or coloured hair, use the lower heat settings.
For thicker hair, use the higher heat settings.
It is suggested to always complete a test on initial use to ensure the
correct temperature is used on the hair type. Start on the lowest
setting and increase the temperature until desired result is achieved.
I = 160°C
II = 180°C
III = 200°C
To Next Page
Loading...
