wire ends should point away from the cab doors. Fix the ends of the wire to the cab door fixing plate
forming a hinge, repeat for the other side. Fix doors in place.
Cab floor and fall plates
Check fit of cab floor (40) to the inside of the cab. Fold back the strapping on the fall plates (41) again
trapping a piece of 0.30mm wire against the edges, locate the fall plates against the slots in the cab
floor and fix the wire in place against the cab floor edge.
Trim a small amount of metal away from the rear edge on cast floor to allow the hinges on the fall plates
to move.
Fix complete assembly to the cab.
Fall plate Rear edge trimmed for fall plate
Front chassis extension
Cut off the guard irons on the chassis extensions at the small fold (42) if not required. Fold down the
small fold at the half etch line and the step support plate and check fit against the chassis side and
behind the front buffer beam. Fix in place and fit the steps (43), the step with the bracket is fitted to the
top position; the bracket may need to be trimmed to fit flush against the chassis.
Front step and chassis overlay
To Next Page
Loading...
