Plasticard cut out
Plasticard-hornguides cut out to clear bearings
If building the sprung version chassis, check the fit of the centre bearings and mark the position of each
bearing.
Offer up the chassis sides to the chassis block with centre bearings in position and axle or axle for non
bearing version and if using securing pins mark position of pins on the block. Drill and tap out the holes
and fit pins (not supplied).
Open up the full axle slots if using bearings, although it may be prudent to open up the actual slots for
the fixed bearing version. Although not necessary remove part of the rear chassis which allows a clear
view through the chassis as the prototype.
When satisfied with the fit, fix in place with glue and soldering the pins to the overlay. Clean up the
chassis sides and fit the remaining bearings using the coupling rods as guides.
To Next Page
Loading...
