Bachmann WOWSound SC-44 - Programming and Configuration; Address Programming; Bachmann E-Z Command System; Configuring with Audio Assist

Programming Your Locomotive:
*Note that this Keep-Alive
®
-equipped
WOWSound
®
decoder may require
a programming booster for reliable
programming operations with some
systems. Visit your local hobby retailer
for more information.
Address Programming:
The default address of all DCC decoders
is 3, so you can start by placing the
locomotive on the rails and selecting
address 3 on your Command Station.
To change the address to another
number less than 126 (99 for some
Command Stations), place the locomotive
on the programming track and follow
your Command Station instructions
for programming CV 1 to your chosen
address less than 126.
For addresses higher than 126, use your
Command Station’s instructions for “long
address” programming.
Bachmann E-Z Command
®
:
For Bachmann’s E-Z Command
®
system,
simply follow your command station
instructions for programming the address
(programming track not required).
&RQĆJXULQJZLWK$XGLR$VVLVW
®
:
With your locomotive addressed and
responding on the DCC mainline, press
function button 8 four times rapidly to
enter Audio Assist. Audio Assist will then
JXLGH\RXWKURXJKFRQĆJXULQJDZLGH
array of features.
Resetting Your Locomotive:
To reset your locomotive to factory
default settings, you can program
CV8=2 or (while operating on DCC)
through Audio Assist.
From the Audio Assist Main Menu, the
button presses, in order, for a full factory
reset are:
Button 4 Button 3 Button 2