WOWSound
®
SC-44 Charger
Paginated Function Mappings
For E-Z Command
®
System
Press function button 8 twice rapidly
to switch from page 1 Sound Mode to
page 1 Light Mode. Every double press
of function button 8 after will rotate
to the next function mapping page.
†
Function Page 1:
Sound Mode Light Mode
F0 Headlights On/Off (F10)
F1 Bell; Ditch Lights Blink
F2 Horn – Long; Ditch Lights Blink
F3 Horn – Short Ditch Lights
F4 Whoosh Number Board
F5 Train Brake Strobe Lights
‡
F6 Prime Mover Marker Lights
F7 Dims Headlight (Rule 17)
F8
1x Press to Mute/Unmute
2x Press to rotate light/sound
mode or page
4x Press to enter Audio Assist
®
†
The function pagination feature found
on this decoder is designed to allow users
with E-Z Command
®
systems to access
more than just 9 functions. For systems
that support all function buttons, it is not
necessary to use the pagination system.
On these systems, you may use the
standard function button control method.
Each “page” of functions will correspond
to a group of up to ten functions: 0
through 9, 10 through 19, and 20 through
28.
‡
For the SC-44 Charger, the strobe lights
will match the behavior seen on the
prototype. These lights will only come
on if the locomotive is in the forward
direction, the headlight is on at full
brightness, and the ditch lights are on.
To Next Page
Loading...