Backfire Zealot S2 - Storage, Maintenance, and Battery Safety; Maintenance Procedures; Battery Safety Precautions

Do frequent maintainance checks, make sure all nuts and bolts are tight before riding.
Clean the skateboard regularly.
Turn o board and controller when not in use.
Recharge the batte in well ventilated area.
Do not charge the batte in area with might wet the board or charging units.
Do not charge the skateboard unattended.
Stop using the product or charging unit if any wire is damaged.
Only use appropriate chargers provided by Backre.
Do not use the board batte to power any other equipments.
STORAGE AND MAINTAINANCE
BATTERY SAFETY
Lithium batteries can explode or cause a re if they are used incorrectly. Therefore, it is
recommended to read the following instructions ve carefully:
Safety Warning:
·If you rode on wet ground with a risk of water entering your batte, please remove and check your batte.
·If there is any evidence of moisture, including water stains, disconnect the batte from your board immediately.
Do not charge or use it!
·Keep the batte in a d and re resistant place to avoid potential re risk (such as a sealed bucket outdoors).
·Do not keep a potentially water damaged batte indoors.
·Do not ship a potentially water damaged batte for seice.
Contact Backre for next steps:
1.In the USA: Tech@helloskate.com
2.Global: Adi@helloskate.com
·Moisture inside a batte pack can cause corrosion and sho circuits in electronics such as the BMS,
lighting or USB boards. This may occur in days or weeks after water ingress.
·The lithium batteries in your pack contain lithium cobalt oxide and organic solvents.These components can
self-sustain a re when a batte is subjected to sho circuits, excessive heat or other stresses.
·Each time before riding the board, carefully check the batte pack and especially the protective seal.
Make it is undamaged and intact. If in doubt, take the batte to a chemical waste disposal facility.
·Never drop the board.
·Store the board with batte inside in a d place.
·Never expose the batte to tempreture above 100 celsius degrees.
·Only use ocal board charger for charging board batte.
·Never leave the board unattended when charging.
·Never make the board work when charging.
·If you are not planning to use the board for about 2 months or longer, Please charge to 50%-60% and
check it once a month. A lithium-ion batte that has been left empty for too long no
longer be charged.
·Fully charge the batte before its rst use to maximize long term batte peormance.
Tip: The batte will enter the hibernation state after the skateboard has been inactive for 7 days.
If it cannot be turned on after receiving the skateboard, please charge and activate it rst.