Backfire Zealot X - Battery Safety and Maintenance; Lithium-ion Battery Hazards and Handling; Regular Maintenance Procedures

Do frequent maintainance checks, make sure all screws are tight before riding.
Clean the bearings regularly.
Turn o board and controller when not in use.
Recharge the batte in well ventilated area.
Do not charge the batte in area with might wet the board or charging units.
Do not leave the board charging unattended.
Stop using the product or charging unit if any wire is damaged.
Only use charging units supplied by us.
Do not use the board batte to power any other equipments.
STORAGE AND MAINTAINANCE
Lithium-ion batte can explode or cause a re if they are used incorrectly. Therefore, it is
recommended to read the following instructions ve carefully:
Safety Warning: If there was potential risk of water damage to the batte before, please disconnect
the batte from the board immediately and stop charging it or use it! Keep the batte in a d , and
re resistant place to avoid potential re risk. Please do not ship a damaged batte! A Li-ion batte
store and release its electrical energy through electrochemical reactions. When electrical energy is
drawn/discharged from the batte, lithium ions move from one electrode to the other.
The electrodes are submerged in a liquid called an electrolyte, which allows for the movement of ions
and consists of lithium salt and organic solvents. It is these organic solvents which are the leading re
hazard in Li-ion batteries. Fuhermore, the positively charged electrode (cathode) in the batte
contains oxygen, which may be released if the batte is subjected to specic stresses, e.g., internal
sho, excessive heat, and more. This means that the Li-ion batteries have all the elements needed
to self-sustain a re.
Tip: The batte will enter the hibernation state after the skateboard has been standing for 7 days.
If it cannot be turned on after receiving the skateboard, please charge and activate it rst.
-Each time before riding the board, carefully check the batte pack and especially the
protective seal. Make it is undamaged and intact. If in doubt, take the batte to a
chemical waste disposal facility.
-Never drop the board.
-Store the board with batte inside in a d place.
-Never expose the batte to tempreture above 100 celsius degrees.
-Only use ocal board charger for charging board batte.
-Never leave the board unattended when charging.
-Never make the board work when charging.
-If you are not plannig to use the board for about 2 months or longer, Please charge to 50%-60% and
charge it once a month. A lithium-ion batte that has been left empty for too long no
longer be charged.
-Charge fully the batte before rst time use. This gives it better long-term peormance.
BATTERY SAFETY