Backyard Creations 259-5091 - Page 7

7
7
AssembleReflectorNOTE: REMOVE PROTECTIVE PLASTIC
COVER ON REFLECTOR PIECES PRIOR TO ASSEMBLY!
Assembly Tip: If necessary for proper alignment of reflector
sections, loosen each screw prior to further assembly and
retighten after sections are aligned.
Reflector PanelsSmall Screw
Cap NutReflector Panel
Reflector PlateReflector Panels
Small ScrewCap Nut
Small ScrewsCap Nutsreflector
tighten all of the Screws and Cap Nuts.
Hardware Used: 9 - Small Screws

8
7
8
Reflector Assembly
Head AssemblyLarge Flat Washers
Reflector StudsReflector AssemblyReflector
StudsLarge Flat WashersReflector Studs
Reflector AssemblyWing Nuts
Wing Nuts
upright position.
Hardware Used: 6 - Large Flat Washers

ASSEMBLY
Contact us for assistance: cservice@welltraveled.net