Backyard Products GABLE - GABLE TRIM INSTALLATION; PARTS REQUIRED FOR GABLE TRIM; INSTALLING GABLE TRIM

51
1-1/4" (3 cm)
Flush to top
of panel.
GABLE TRIM
PARTS REQUIRED:
2 x 3 x 58" (5 x 7,6 x 147,3 cm)
x4
CDD
Flush
CDD
CDD
x24
DOOR
FINISH
Position (1) CDD ush to front panel edge and center on right edge of groove
(Fig. A). Install trim with (8) 1-1/4" screws from inside.
Install (2) screws at seam (Fig. B).
Install 2nd CDD ush to panel edge and ush to installed CDD (Fig. A).
Secure trim with (8) 1-1/4" screws from inside. Install (2) screws at seam (Fig. B).
Repeat steps to attach the back trim.
You have attached your upper trim. Continue to attaching your endcaps.
2
BEGIN
¸
1
Fig. A
Fig. B
8" (20,3 cm)
Approximately