Backyard Products GABLE - BACK WALL GABLE TRIM INSTALLATION; PARTS REQUIRED FOR BACK GABLE TRIM; INSTALLING BACK WALL GABLE TRIM

52
FINISH
Clamp or hold trim XMA onto gable panel seam and up against gable trim.
Ensure XMA is level.
From the inside, fasten XMA with 3/4" screws, in the pattern shown.
Your back wall gable trim is now installed.
2
BEGIN
¸
1
BACK WALL GABLE TRIM
PARTS REQUIRED:
x1
XMA
11/16 x 2-1/2 x 60-5/8" (1,7 x 6,3 x 154 cm)
3/4" (1,9 cm) x11
DOOR
Flush
Flush
GABLE TRIM
LEVEL
XMA
XMA
INSIDE
(11) 3/4" (1,9 cm)
Screws
1-1/4"
(3,2 cm)
2-1/2"
(6,3 cm)
SEAM