Backyard Products GABLE - RAFTERS INSTALLATION; PARTS REQUIRED FOR RAFTERS; POSITIONING AND SECURING RAFTERS

22-1/4"
(56,5 cm)
22-1/4"
(56,5 cm)
24"
(61 cm)
24"
(61 cm)
54
RAFTERS
3" (7,6 cm)
FINISH
Locate rafters directly over studs and ush to overhang in wall frame (Fig. A).
Check that you have the measurements shown.
Screw through soft panel into rafters with (1) 2" screw (Fig. A).
Repeat steps to install (3) additional rafters.
Secure with (2) 3" screws at each end (Fig. B). Re-tighten 2" screws if neccessary.
Your rafters are now installed.
Flush
2
BEGIN
¸
1
PARTS REQUIRED:
pre-assembled
x3
x12
x6
Screw into top
plate.
Align over studs.
Maintain the measurements between rafters.
2" (5 cm)
2" (5 cm)
Screw
Fig.A
1" (2,5 cm)
Fig. B
DOOR
NOTE: Measurements from inside of panels