SECTION 3: ENGINE
PAGE 21
Kohler
This machine has an oil drain hose installed on the
engine to allow for easier oil changes. Bad Boy
recommends that the oil and filter be changed at
intervals of 50 usage hours or yearly, whichever
occurs first. The oil capacity is 2 quarts. Bad Boy
10W-30 synthetic blend engine oil is recommended
for maximum protection.
3.1 Changing your engine oil and oil filter
1) Remove oil dipstick and open oil
drain. Allow oil to completely drain.
(Make sure to have an oil pan ready to
capture old oil and properly dispose old
oil.)
2) Clean area around oil filter. Place a
container under the oil filter to capture
any oil and remove filter. Wipe off
mounting surface and reinstall drain plug.
Torque to 10 ft*lb.
3) Place new filter in shallow pan with open
end up. Fill with new oil until oil reaches
the bottom of the threads. Allow 2
minutes for oil to be absorbed by filter
material.
4) Apply a thin film of clean oil to rubber
gasket on new filter
5) Refer to instructions on oil filter for
proper installation.
To Next Page
Loading...
Need help?
General
