Bad Boy MZ MAGNUM User Manual

SECTION 2: DRIVE BELT
S
h
o
wn to th
e
right
is the MZ pump belt tensioner. Tightening
the two 3/4" jam nuts on the right side will increase the belt
tension.
The tension should be adjusted so that there is
bet
ween 50 to 55 lbs. of tension on the belt. This
can be checked
with a belt tension gauge as shown to the right.
PAGE 20

Bad Boy MZ MAGNUM Specifications

General

Horsepower	25 HP
Deck Material	7-gauge steel
Spindle Material	Aluminum
Blade Tip Speed	18, 500 fpm
Cutting Width	60 inches
Cutting Height	1.5 - 4.5 inches
Warranty	2-Year Bumper-to-Bumper / 3-Year Engine