EasyManuals Logo

Bad Boy RENEGADE Series Service Manual

Bad Boy RENEGADE Series
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
PAGE 22
FUEL FILTER
The fuel filter is located in the fuel line. Reference section
4 for the recommended replacement interval for the fuel
filter. Prior to the removal of the old filter, note the
direction of fuel flow as indicated on the filter. Always use
new fuel line clips. Always perform maintenance outdoors
or in a well-ventilated area. Do not smoke or allow any
open flames in the vicinity of any maintenance activities.
CHANGING YOUR FUEL FILTER
1. Locate your fuel filter and note the direction of
fuel flow.
2. Clamp the fuel line on both sides of the fuel filter
using fuel line clamps.
3. Remove the fuel line clips from each side of the
fuel filter and remove the fuel filter.
4. Place the new fuel filter in the same direction as
the old and place new fuel line clips into place.
5. Remove fuel line clamps referenced in step 2.
6. Clean area of any spilled fuel.
Fuel Filter
Verify Flow
Direction
Fuel Line
Clamp
Fuel Line
Clamp
Fuel Line
Clip
Fuel Line
Clip
Fig. 18

Other manuals for Bad Boy RENEGADE Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bad Boy RENEGADE Series and is the answer not in the manual?

Bad Boy RENEGADE Series Specifications

General IconGeneral
Spindle MaterialCast Iron
Horsepower37 HP
Cutting Width72 inches
TransmissionHydro-Gear ZT-4400
Cutting Height1.5 - 5 inches

Related product manuals