Why does the BAFANG BBS01 Bicycle rim have a buckle or spokes coming loose?
For major spoke tension issues, it's recommended to have a competent wheel builder address them. You can also find helpful tutorials online on how to adjust spoke tension.
How to arrange a battery capacity test for my BAFANG Bicycle?
Please contact us by submitting a support ticket to arrange the return of your battery for testing.
What to do if I see an error message on the BAFANG BBS01 Bicycle display?
Please refer to display manual for error code definition and if needed, report the error code to us in a service ticket.
What to do if BAFANG BBS01 display won’t turn on, unless the battery charger is plugged in?
Check the display connections and ensure the battery is charged. If the display only turns on when the battery charger is plugged in, you will have to contact our support team.
What to do if the BAFANG BBS01 Bicycle motor runs backwards?
Remove the motor from the frame and switch the direction.
Why drink bottle holder bolts won’t tighten on BAFANG BBS01?
You may require some longer bolts.
What to do if the wiring to a part of the BAFANG BBS01 kit is not long enough?
Please contact us for longer wiring.
How to use e-brakes with hydraulic or integrated brakes on my BAFANG BBS01?
You can either choose not to use e-brake handles (the kit will still function), or purchase e-brake cut-off sensors that can mount to your existing brake handles, regardless of type.
Where to buy replacement spokes for BAFANG Bicycle?
Spare spokes are available for purchase in the spares section online. You can find the correct type and length for your kit there.
What to do if the BAFANG BBS01 Bicycle display turns on but the motor doesn't activate?
If the display turns on but the motor doesn't activate, check the motor plug from the controller. Ensure the plug is fully inserted to the indicator line. Insufficient slack in the motor cable can cause the plug to pull out slightly when the handlebars are twisted.
Steps to remove existing cranks and bottom bracket before motor installation.
Install the BBS motor into the bike's bottom bracket and secure it.
Install the new cranks onto the motor axle and attach pedals.
Mount the battery cradle to the frame and secure the battery.
Connect all components according to color coding and wire diagrams.
General| Motor Type | Brushless Gear Motor |
|---|---|
| Voltage | 36V |
| Max Torque | 80 Nm |
| Compatibility | 68mm Bottom Bracket |
| Waterproof Rating | IP65 |
| Controller | Integrated |
| Throttle | Optional |
| Power | 250W |
| Weight | 3.6 kg |
| Display | Optional |
| Maximum Speed | 25 km/h |
| Pedal Assist Levels | 9 levels |
To Next Page
