To Next Page
N
ndixonSep 2, 2025
How to manage a crowded handlebar on a BAFANG BBS01 Bicycle?
- JJoshua BurnettSep 2, 2025
If you have a crowded handlebar, try shuffling components around to create space. Alternatively, consider using a thumb throttle.
How to manage a crowded handlebar on a BAFANG BBS01 Bicycle?
If you have a crowded handlebar, try shuffling components around to create space. Alternatively, consider using a thumb throttle.
What if the BAFANG BBS01 Bicycle motor still doesn't fit in the bottom bracket?
If there isn't enough thread extending out the other side of your bottom bracket (10mm+ required) or the motor won't slide in due to a small diameter, you may need assistance from a bicycle mechanic.
What to do if the BAFANG BBS01 Bicycle motor does not fit in the bottom bracket?
Ensure your bike has an internal bottom bracket between 68 and 73mm wide for compatibility. If there are small defects like burrs, smooth them out with a file.
How to troubleshoot a BAFANG BBS01 Bicycle kit that won’t turn on?
If the kit won’t turn on, use a multimeter to test the DC voltage output from the base of the battery. For a 36V kit, the voltage should be over 41V. If it's not, the battery may need testing and potential replacement.
How to fix a high pitched rattling noise when accelerating on my BAFANG BBS01?
A high-pitched rattling noise during acceleration may be due to loose parts. Check if the noise comes from the motor or from loose components like spokes or bolts on the rear rack. Tighten any loose parts to resolve the issue.
What causes my BAFANG Bicycle battery to cut out intermittently?
Intermittent battery cut-outs can happen if the battery is low on power or if you're going up a steep hill with a load on the motor. This can cause a voltage cut-off due to an overloaded controller.
Why my BAFANG BBS01 Bicycle kit loses power over bumps?
Losing power over bumps can occur if connections are loose. Check all connections to ensure all plugs are fully connected. Also, verify that the battery is securely locked to the cradle and not loose.
Steps to remove existing cranks and bottom bracket before motor installation.
Install the BBS motor into the bike's bottom bracket and secure it.
Install the new cranks onto the motor axle and attach pedals.
Mount the battery cradle to the frame and secure the battery.
Connect all components according to color coding and wire diagrams.
General| Motor Type | Brushless Gear Motor |
|---|---|
| Voltage | 36V |
| Max Torque | 80 Nm |
| Compatibility | 68mm Bottom Bracket |
| Waterproof Rating | IP65 |
| Controller | Integrated |
| Throttle | Optional |
| Power | 250W |
| Weight | 3.6 kg |
| Display | Optional |
| Maximum Speed | 25 km/h |
| Pedal Assist Levels | 9 levels |
