14
BF-UM-C-DP C171-EN November 2019
7.8 ERROR CODE DEFINITION
The display can show the errors of a pedelec. If an error is detected, the wrench icon
appears on the display and one of the following error codes will be displayed.
Note: Please read carefully the description of the error code. When the error code appears, please
first restart the system. If the problem is not eliminated, please contact your dealer or
technical personnel.
Error Declaration Troubleshooting
04 The throttle has fault.
1. Check the connector of throttle whether
they are correctly connected.
2. Disconnect the throttle, If the problem still
occurs, please contact your retailer.
(only with this function)
05
The throttle is not back in its correct
position.
Check the throttle can adjust back into its
correct position, if the situation does not
improve, please change to a new throttle.(only
with this function)
07 Overvoltage protection
1. Remove the battery.
2. Re-Insert the battery.
3. If the problem persists, please contact your
retailer.
08
Error with the hall sensor signal
inside the motor
Please contact your retailer.
09 Error with the Engine phase’s Please contact your retailer.
10
The temperature inside the engine
has reached its maximum protection
value
1. Turn off the system and allow the Pedelec
to cool down.
2. If the problem persists, please contact your
retailer.
11
The temperature sensor inside the
motor has an error
Please contact your retailer.
12
Error with the current sensor in the
controller
Please contact your retailer.
13
Error with the temperature sensor
inside of the battery
Please contact your retailer.
To Next Page
Loading...
Need help?
General
