Need help?Do you have a question about the Bahco BCL20IB and is the answer not in the manual?
Explanations for icons related to safety precautions, handling, and environmental conditions.
Icons indicating the need for safety glasses and gloves.
Icons for reading the user guide, general waste disposal, and local recycling.
Icons indicating compliance with EC, UK CA, Australian, NZ, and California energy standards.
Fully charge batteries before first use.
Insert battery and press the on/off button until the LED is green and a beep sounds.
Double-click the trigger to open the blade and start working.
Adjust blade opening to full (32mm) or half (15mm) by pressing trigger.
Remove cover, unlock/unscrew center bolt, and separate system and blade.
Check and change counter blade if needed. Clean and grease all parts.
Assemble system, tighten central nut (0.2 Nm), and secure bolts/cover.
Tighten the lower screw to complete blade change.
Close blades, switch off tool, and disconnect the battery.
Charge the battery and lubricate the cutting head.
Sharpen the blade using SHARP-X or LS CORINDON as recommended.
To Next Page
General