Bailey Infi90 - Page 9

Safety Summary
VI
GENERAL
WARNINGS
SPECIFIC
WARNINGS
SPECIFIC
CAUTIONS
Equ1pment Environment
A I components whether 1n transportation operation or storage
must be n a noncorros1ve env ronment
Electrical Shock Hazard During Maintenance
D sconnect power or take precaut ons to ensure that co 1tact w th
energ zed parts s avo ded when serv c ng
Special Handling
Th s module uses Electrostat c Sens t1ve Dev1ces (ESD)
Ensure that
the c rcu~ breaker for theIne power supply s OFF as you do
these steps Do not tum thiS breaker on unt the nstruct ons tel you
(o3-3)
The plast c covers on the Modu e Mount ng Un t backp ane
protect agamst nc dent a contact w th AC Do net remove
these covers (p 3 8)
To prevent shock when remov ng the power supply modu e wa t
5
seconds to a ow 1ne f ter capac tors to d scharge before han
d ng module Then, s de the module the rest of the way out Do
not grab the modu e by the heat s nk ( t may be hot) support t by
the bottom edge of the CirCUit board (p 3 1 o, 7 3)
D
sconnect power before nsta 1ng d pshunts for save modules
on the MMU backp ane (slave expander bus) Fa lure to do do
cou d resu t n severe or lata shock (p 3 1 0}
Improper sw tch sett ng can cause permanent damage to the PF
Board I exposed to the h1gher 1nput voltage (p 3 1 o)
I E96 506A
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com