Bajaj pulsar DTS-i - Page 130

DISMANTLING ENGINE SUB ASSEMBLIES
Camshaft Dismantling
Remove :
Using Special Tool : Bearing Pullers - 37
10DJ 74 for Bearing 39 2542 20, 37
10DJ 75 for Bearing 39 1880 20
• Bigger Bearing using sp. tool from
camshaft assembly
• Small Bearing
Washer
(A)
(B)
• (C)
Gear Starter Clutch
Remove :
Remove :
• Place the gear starter clutch on arbor press as shown in photo
• Using Bearing Driver Set (P. No.: 37 1030 61)
• Needle roller bearing
A
B
C
Pulsar 150/180 DTS-i
Service Station Manual
126
Dealer Development Center
Akurdi Pune