Bajaj pulsar DTS-i - Page 148

ASSEMBLY - ENGINE
Fit :
• 2 Dowels
• Oil Pump Assembly
• 3 Bolts
Fit :
• Starter Motor
• Clutch cover gasket
• 2 Dowels
• Clutch Cover
• 10 bolts
• Bracket Clutch Cable
• Starter Motor Cap
• Screw’
Note : Do not apply any grease to stick ‘Gaskets’ to the ‘Clutch Cover / Magneto
Cover’ or ‘Crankcase’. As grease deteriorates the gasket material and reduces
sealing efficiency.
Magneto Side
Fit :
• Shaft Starter Counter
• Gear complete starter counter assly
• Collar
Note : Always apply a thin layer of grease on to the roller bearing of gear complete
starter counter assembly.
Fit :
• Woodruff key
• Magnet along with gear starter clutch
Note :
Always apply a thin layer of grease to the roller bearing of gear starter clutch.
Lubricate the one way clutch using the Molikote grease.
•
•
Pulsar 150/180 DTS-i
Service Station Manual
144
Dealer Development Center
Akurdi Pune