Bajaj pulsar DTS-i - Page 192

SOP FOR SWING ARM REPLACEMENT
Remove :
• 2 flange nuts.
Remove :
• Allen bolt.
• Nut.
• Silencer complete.
Note :
1. Slide down the flange of silencer for easy removal of silencer assembly.
2. Ensure that the silencer is not in hot condition or else may cause injury / burn.
Remove :
• Circlip.
• Nut.
• Torque link rod.
Remove :
• Brake rod nut.
• Brake rod.
• Distance piece.
• Spring.
Pulsar 150/180 DTS-i
Service Station Manual
188
Dealer Development Center
Akurdi Pune
SOP Av)>g aim< bdlvi miT[
kiQi[
fl[ºj nT 2 n>br
&>
kiQi[
b\[k ri[D nT
b\[k ri[D
D)ATºs p)s
Ap\)>g
kiQi[
a[ln bi[ÃT
nT
siyl[nsr kÀpl)T
ni[>F
1
2.siyl[nsr hi[T k>D)Snmi n hi[y t[ ¹yin riKv&>
kiQi[
srkl)p
nT
Ti[k l)ºD ri[D