SOP FOR MASTER CYLINDER PISTON KIT REPLACEMENT
• Fill brake fluid up to MAX level.
• Remove the air by bleeding process. Maintain oil level in between MAX
& MIN level.
• Re-fit rubber diaphragm & reservoir cap. Check brake effectiveness.
• Drive the vehicle & confirm brake effectiveness.
Note :
• Use DOT-3 / brake fluid from a sealed container.
• Ensure no leakage of brake fluid through brake hose / benjo bolts /
caliper assembly.
• Carry out air bleeding if required.
DOT-4
Pulsar 150/180 DTS-i
Service Station Manual
206
Dealer Development Center
Akurdi Pune
To Next Page
Loading...
