VEHICLE IDENTIFICATION & CONTROLS
Pulsar 150/180 DTS-i
Service Station Manual
34
Dealer Development Center
Akurdi Pune
A
B
C
C
D
C. Horn Button : ( ) Press button for sounding horn.
D. Pass Switch : Press the switch to flash the head light. It is used to
give signal to vehicles coming from opposite side while overtaking.
Left Handle Bar Switches
A. Dipper Switch : When headlight is ON, High or Low beam can be
selected with the dipper switch. Hi beam indicator light located on
Speedo console will light up when high beam is selected.
: High Beam : Low beam
B. Turn Signal Switch : When the turn signal knob is turned to Left (
) or Right ( ) respective indicator will start blinking, to stop blinking
push the knob in & release.
Right Handle Bar Switches
E. Head Light Switch : It has 3 positions.
: All lamps 'OFF'.
: While engine running, Tail lamp and Pilot
lamps ‘ON’.
: While engine running, Headlamp, Pilot lamp,
Tail lamp, Meter lamps ‘ON’.
F. Starter Button : It operates the electric starter when clutch lever is
depressed with transmission in any gear. It is recommended to start
engine with transmission in neutral.
G. Engine Kill Switch : The engine kill switch is for emergency use.
During emergency move the engine kill switch to the ‘OFF’ ( )
position.
CAUTION : While starting ensure that engine kill
switch is in ON ( ) position. Keeping the kill switch
in OFF position Engine will not start.
E
F
G
To Next Page
Loading...
