IMPORTANCE OF PM SCHEDULE EXECUTION
Pulsar 150/180 DTS-i
Service Station Manual
45
Dealer Development Center
Akurdi Pune
Servicing with Water Wash
1. Cover tail end of silencer with PVC cap to avoid water entry in silencer.
2. Set water pressure for vehicle washing is 25 bar max & s
.
washer et the
nozzle in spray mode
5. Wash the vehicle by keeping nozzle 2 meters away from parts.
3. Clean the exterior surface of engine metal parts by diesel or kerosene
with soft nylon brush.
Caution :
Vehicle washing without covering silencer tail end will result in water entry
into silencer causing rusting of silencer.
4. Dismantle the small chain cover & clean the area between magneto
cover and engine sprocket by using nylon brush and kerosene or diesel.
To Next Page
Loading...
