Pulsar 150/180 DTS-i
Service Station Manual
49
Dealer Development Center
Akurdi Pune
5. Inspect oil quality.
6. Clean ferrous burr accumulated on the tip of magnetic drain plug and
then refit.
7. Tighten drain plug to recommended torque by torque wrench.
8. It is important to measure oil quantity after draining. This is important to
understand the oil consumption pattern.
9. During the interval- from one oil change to the next oil change, engine
oil quantity should not be more than 50 ml. per 1000 Kms. If oil drop is
more check for external oil leakage, smokey exhaust & piston ring wear.
10. Clean centrifugal oil filter (applicable for Pulsar 150 / 180 / 220 /
Avenger 220).
13. Use Bajaj Genuine oil only as per the recommended grade.
IMPORTANCE OF PM SCHEDULE EXECUTION
To Next Page
Loading...
