Pulsar 150/180 DTS-i
Service Station Manual
68
Dealer Development Center
Akurdi Pune
IMPORTANCE OF PM SCHEDULE EXECUTION
Tappet Clearance Setting
1. Do tappet setting at engine cold condition.
2. Ensure the ‘T’ mark on the ‘Rotor’ match with the mark on the
‘Crankcase LH’. At this stage the ‘Piston’ is at TDC and both the
‘Tappets’ are free.
4. Put the feeler gauge, measure and adjust the clearance.
5. Lock the nut holding screw with special tool after getting desired
clearance.
6. Again check the tappet clearance with gauge. The gauge should slide
with slight resistance between tappet and valve stem head feeler and
tighten the check nut with a spanner.
Inlet Valve : 0.05 mm • Exhaust Valve : 0.1 mm
Required Special Tools & Equipment
Filler Gauge Tappet Adjusting Tool
To Next Page
Loading...
