ENGINE TUNE UP
Pulsar 150/180 DTS-i
Service Station Manual
75
Dealer Development Center
Akurdi Pune
• Keep throttle at zero position.
• On connecting multi meter to Reed Switch coupler it should show
continuity.
0.00
Check throttle lever movement by rotating it with hand. It should not
be sticky in operation and should return back it self on releasing.
bracket Multimeter should show continuity.
• Magnet should not touch with reed switch.
• Gap between Magnet & Reed Switch should not be more than
2.5mm.
• Movement of throttle lever with magnet assembly and Reed
Switch fitted should be free.
• Accelerator cable play: 2-3 mm by adjusting the Adjuster
• Protude stopper of the throttle lever bracket must on idling screw
tip.
Gap
2.5mm max.
Reed Switch Setting & Checking
Reed Switch : Setting
Reed Switch : Checking
To Next Page
Loading...
