SOP for Carburettor cleaning
• Ensure fuel cock knob at 'OFF'
position.
• Remove fuel pipe from fuel cock
side.
• Loosen drain screw and flush
out petrol from the “Carburetor
bowl”.
• Then re-tighten the drain screw.
• Loosen clamps of rubber duct.
• Remove intake manifold bolts and take out carburetor.
• Remove Philips screws securing the “Carburetor bowl” to the Carburetor body.
• Take out “Carburetor bowl”
• Pour out sludge and sediment from “Carburetor bowl”
• Clean the “Carburetor bowl” by petrol & soft nylon brush.
STANDARD OPERATING PROCEDURE
Pulsar 150/180 DTS-i
Service Station Manual
77
Dealer Development Center
Akurdi Pune
To Next Page
Loading...
