NOTE: This wiring diagram is meant as a guide only and not as instructions on how to
wire the RCD. Different brands of RCD may be wired differently. The RCD must be
wired by a qualified and licensed electrician.
Electrical
Electrical
Service C
Service C
onfiguration
onfiguration
Options
Options
Default Setting:
Single Service (1 x 16 Amp)
Single Service (1 x 32 Amp)
Dual Service (2 x 16 Amp)
3-Phase Service (3 x 16 Amp)
3-Phase Service (3 x 32Amp)
Single Service (1 x 16 Amp or 1 x 32 Amp)
3 Wires (1 Line + 1 Neutral + 1 Protective Earth)
Protective Earth wire (Green/Yellow) must be connected to system ground terminal as
marked.
All equipment (pumps, blower, and heater) runs on service line L1.
To Next Page
Loading...
