Baldor BC142 - Page 9

3.1 Standard Features
1 Plug-In Horsepower Resistor® – Eliminates the need to calibrate the control for IR Compensation
and Current Limit when used on various horsepower motors.
2 Auto-Inhibit® – Allows the control to be rapidly switched “on” and “off” using the AC line.
3 Inhibit and Enable – Allows the control to be turned “on” and “off” using electronic switching.
4 Trimpots – Minimum Speed (MIN), Maximum Speed (MAX), IR Compensation (IR), Current Limit (CL),
Acceleration (ACCEL), and Deceleration (DECEL).
5 Jumpers – AC Line Input Voltage Selection (J1 (Catalog No. BC142-6 only)), Motor Voltage and DC
Tach-Generator Selection (J2).
6 Protection Features – MOV transient protection. Short Circuit protected (at motor only).
7 Diagnostic LEDs – Power On (PWR ON) and Current Limit (CL).
8 Catalog No. BC141 operates on 115 Volt AC line input with 90 Volt DC motors.
9 Catalog No. BC142 operates on 230 Volt AC line input with 180 Volt DC motors or 90 Volt DC motors
(step-down). - Jumper Selectable.
10 Catalog No. BC142-6 can operate on 115 Volt AC line input with 90 Volt DC motors and 230 Volt AC
line input with 180 Volt DC motors or 90 Volt DC motors (step-down). - Jumper selectable.
11 Armature or DC Tach-Generator feedback.
12 SMT construction.
8