Balex BXT 3210 E - Adjusting Front Wheel Height; Adjusting Rear Wheel Height; Operating the Mower

20
ENGLISH EN
ADJUSTING THE FRONT WHEEL CUTTING HEIGHT
POSITION (FIG. 2A)
1. Turn the mower upside down.
2. Pull the wheel axle towards the front of the mower.
3. Locate the wheel axle into the desired cutting height
adjustment position.
NOTE: Make sure that both front right and left wheels are
located in the same cutting height adjustment position.
ADJUSTING THE REAR WHEEL CUTTING HEIGHT
POSITION (FIG. 2B)
1. Turn the mower on its side.
2. Pull the rear wheel axle towards the mower’s catcher
ap.
3. Locate the wheel axle into the desire cutting height
adjustment position.
NOTE: Make sure that both rear right and left wheel are
located in the same cutting height adjustment positon.
CUTTING HEIGHT POSITIONS (FIG. 2C)
1. 20mm (lowest position).
2. 35mm.
3. 50mm (highest position).
4. Operating
WARNING! Before connecting to the mains supply, always check the switch is in o󰀨 position.
Connect the plug into the RCD protected power supply.