Page 5 Model 205ce and 205Mce Operation Manual
TROUBLESHOOTING
The following is a list of troubleshooting
questions:
Are the pickup and cable in good condition and
connected properly?
Is the power ON? Is the battery good?
Is the display on?
Are the switches inoperative, or experiencing
other switching problems?
Troubleshooting Guide
Symptom: No Display
Possible Cause: No power or supply voltage
Solution:
Check batteries. Replace if necessary. Check
OFF/ON switch.
Symptom: No Indication on Meter
Display
Possible Cause: No vibration signal
Solution:
Check vibration pickup and cable. Possible
defective pickup. Possible defective display.
Symptom: Amount Readings Unstable
Possible Cause: Machine defect. Improper
setup (low range)
Solution:
Check vibration pickup for proper installation.
Check for loose machine components. Verify
pickup and cable connections. Signal to noise
ratio is low (low range in displacement). Reduce
noise, increase Amplitude range, or change
Amplitude units.
TECHNICAL SUPPORT
For additional technical information, contact
Balmac. Additional information about vibration is
available in our Vibration Analysis Training
Manual and our “B” Book Series.
For information on vibration standards for ISO
and ANSI, contact Balmac or check the Internet.
All questions and problems should be directed to
the factory Monday through Friday, 8:00 A.M. to
5:00 P.M. Eastern Time at the following
numbers:
Telephone: 614-873-8222
Email: sales@balmacinc.com
Ship To: BALMAC, INC.
8205 Estates Pkwy, Ste N
Plain City, OH 43064-8080
SERVICE SUPPORT
The instrument is warranted for a period of two
years. It is recommended you contact Balmac
before returning equipment for service.
Instrumentation returned prepaid to Balmac
during the warranty period will be repaired or
replaced without charge if it has not been
subjected to misuse. Return freight is
chargeable. Equipment returned for service
should be packed in a suitable shipping
container.
To Next Page
Loading...